Please be sure that your base pin is fully inserted into the frame of your revolver. The base pin needs to be fully engaged into the locked position. Failure to do so will result in the transfer bar hitting the back side of the fire pin thereby causing your firearm to lock up. When you insert your base pin, you will feel the base pin lock nut reset itself within the groove of the base pin. If the base pin is not fully inserted as described above, your revolver can jam.
Articles in this section
- Can I put adjustable sights on my Rough Rider Revolver.
- What ammunition can I use with my Rough Rider 32 cal revolver?
- What ammunition can I use with my Rough Rider 22 combo revolver?
- My Big Bore locks up, what do I do?
- How do I install a Fiber on my adjustable sight Rough Rider?
- How do I clean the silver satin finish on my Rough Rider?
- How do I adjust the point of aim on my Big Bore Rough Rider (.357, 44-40, .45) calibers?
- How do I adjust my adjustable sight Rough Rider?
- How can I tell the difference between a .22 WMR and a .22 LR?
- Can I use a 9 shot cylinder in my 6 shot Rough Rider?
Article is closed for comments.